ZyXEL Communications ZyXEL G-1000 v2 User Manual
ZyXEL G-1000 v2 User’s Guide
34
Chapter 2 Introducing the Web Configurator
Figure 4 Change Password Screen
6 On this screen you can access the wizard setup or the advanced setup.
Click Go to Advanced setup to access the status screen of the web configurator
.
Note: The management session automatically times out when the time period set in
the Administrator Inactivity Timer field expires (default five minutes). Simply log
back into the G-1000 v2 if this happens to you.
back into the G-1000 v2 if this happens to you.
2.3 Resetting the G-1000 v2
If you forget your password or cannot access the web configurator, you will need to reload the
factory-default configuration file or use the RESET button on the top panel of the G-1000 v2.
Uploading this configuration file replaces the current configuration file with the factory-
default configuration file. This means that you will lose all configurations that you had
previously and the password will be reset to 1234.
factory-default configuration file or use the RESET button on the top panel of the G-1000 v2.
Uploading this configuration file replaces the current configuration file with the factory-
default configuration file. This means that you will lose all configurations that you had
previously and the password will be reset to 1234.
2.3.1
.
Procedure To Use The Reset Button
Make sure the SYS light is on (not blinking) before you begin this procedure.
1
Press
the RESET button for ten seconds or until the SYS light starts to blink, and then
release it. If the SYS light begins to blink, the defaults have been restored and the G-1000
v2 restarts. Otherwise, go to step 2.
v2 restarts. Otherwise, go to step 2.
2
Turn the
G-1000 v2 off.
3
While
pressing the RESET button, turn the G-1000 v2 on.
4
Continue
to hold the RESET button. The SYS light will begin to blink and
flicker very
quickly after about 20 seconds. This indicates that the defaults have been restored and the
G-1000 v2 is now restarting.
G-1000 v2 is now restarting.
5
Release
the RESET
button and wait for the G-1000 v2 to finish restarting.