ZyXEL Communications MAX-306M1 User Manual
Chapter 9 The VPN Transport Screens
User’s Guide
103
9.3.4 Customer Interface Setup
Click the Edit icon in the ADVANCED > VPN Transport > Customer Interface
screen to open the Customer Interface Setup.
screen to open the Customer Interface Setup.
Customer interfaces map traffic onto specific Ethernet pseudowires for transport
over the WiMAX network. There is also a default customer interface for routing
traffic that does not possess a VLAN tag.
over the WiMAX network. There is also a default customer interface for routing
traffic that does not possess a VLAN tag.
Figure 39 ADVANCED > VPN Transport > Customer Interface Setup
Associated
Ethernet
Pseudowire
(Ingress,
Egress)
Ethernet
Pseudowire
(Ingress,
Egress)
This displays the number of the Ethernet pseudowire that this interface
uses, as well as the ingress and egress MPLS (Multi-Protocol Label
Switching) VC (Virtual Circuit) label numbers.
uses, as well as the ingress and egress MPLS (Multi-Protocol Label
Switching) VC (Virtual Circuit) label numbers.
DSCP
This displays the DiffServ Control Point value you previously entered in
binary. This determines the pseudowire’s priority on the network. The
DSCP value is displayed in binary notation and has six bits.
binary. This determines the pseudowire’s priority on the network. The
DSCP value is displayed in binary notation and has six bits.
Interface
Description
Description
This displays the information you previously entered describing the
interface. For the default interface, interface 0, the description reads
“for routing / NAT”.
interface. For the default interface, interface 0, the description reads
“for routing / NAT”.
Action
Click the Edit icon to set up a new interface or alter the configuration of
an existing interface.
an existing interface.
Click the Delete icon to remove an existing interface.
Table 26 ADVANCED > VPN Transport > Customer Interface (continued)
LABEL
DESCRIPTION