ZyXEL Communications P-660HNU-Fx User Manual
Chapter 6 Wireless
ADSL Series User’s Guide
109
6.2.1 No Security
Select No Security to allow wireless stations to communicate with the access points without any
data encryption or authentication.
data encryption or authentication.
Note: If you do not enable any wireless security on your ZyXEL Device, your network is
accessible to any wireless networking device that is within range.
Figure 30
Wireless > General: No Security
The following table describes the labels in this screen.
6.2.2 Basic (Static WEP/Shared WEP Encryption)
WEP encryption scrambles the data transmitted between the wireless stations and the access points
(AP) to keep network communications private. Both the wireless stations and the access points
must use the same WEP key.
(AP) to keep network communications private. Both the wireless stations and the access points
must use the same WEP key.
There are two types of WEP authentication namely, Open System (Static WEP) and Shared Key
(Shared WEP).
(Shared WEP).
Open system is implemented for ease-of-use and when security is not an issue. The wireless station
and the AP or peer computer do not share a secret key. Thus the wireless stations can associate
with any AP or peer computer and listen to any transmitted data that is not encrypted.
and the AP or peer computer do not share a secret key. Thus the wireless stations can associate
with any AP or peer computer and listen to any transmitted data that is not encrypted.
Shared key mode involves a shared secret key to authenticate the wireless station to the AP or peer
computer. This requires you to enable the wireless LAN security and use same settings on both the
wireless station and the AP or peer computer.
computer. This requires you to enable the wireless LAN security and use same settings on both the
wireless station and the AP or peer computer.
In order to configure and enable WEP encryption, click Network Settings > Wireless to display
the General screen. Select Basic as the security level. Then select Static WEP or Shared WEP
from the Security Mode list.
the General screen. Select Basic as the security level. Then select Static WEP or Shared WEP
from the Security Mode list.
Table 16
Wireless > General: No Security
LABEL
DESCRIPTION
Security Level
Choose No Security from the sliding bar.