ZyXEL Communications MES3500-24F User Manual

Chapter 31 PPPoE

MES3500-24/24F User’s Guide

Use this screen to set whether the PPPoE Intermediate Agent is enabled on a VLAN and whether the 
Switch appends the Circuit ID and/or Remote ID to PPPoE discovery packets from a specific VLAN.

Click the VLAN link in the Intermediate Agent screen to display the screen as shown. 

Advanced Application > PPPoE > Intermediate Agent > VLAN 

The following table describes the labels in this screen. 

Advanced Application > PPPoE > Intermediate Agent > VLAN

Show VLAN 

Use this section to specify the VLANs you want to configure in the section below.

Start VID

Enter the lowest VLAN ID you want to configure in the section below.

End VID

Enter the highest VLAN ID you want to configure in the section below.

Apply

Click Apply to display the specified range of VLANs in the section below.

VID

This field displays the VLAN ID of each VLAN in the range specified above. If you configure the 
* VLAN, the settings are applied to all VLANs.

*

Use this row to make the setting the same for all VLANs. Use this row first and then make 
adjustments on a VLAN-by-VLAN basis. 

Note: Changes in this row are copied to all the VLANs as soon as you make them.

Enabled

Select this option to turn on the PPPoE Intermediate Agent on a VLAN.

Circuit-id 

Select this option to make the Circuit ID settings for a specific VLAN take effect.

Remote-id 

Select this option to make the Remote ID settings for a specific VLAN take effect.

Apply

Click Apply to save your changes to the Switch’s run-time memory. The Switch loses these 
changes if it is turned off or loses power, so use the Save link on the top navigation panel to 
save your changes to the non-volatile memory when you are done configuring.

Cancel

Click Cancel to begin configuring this screen afresh.