ZyXEL Communications MES3500-24F User Manual

Chapter 7 System Status and Port Statistics

MES3500-24/24F User’s Guide

The following table describes the labels in this screen. 

Status 

Port

This identifies the Ethernet port. Click a port number to display the Port Details 
screen (refer to 

Name

This is the name you assigned to this port in the Basic Setting > Port Setup 
screen.

Link

This field displays the speed (either 10M for 10Mbps, 100M for 100Mbps or 
1000M for 1000Mbps) and the duplex (F for full duplex or H for half). It also 
shows the cable type (Copper or Fiber) for the combo ports.

This field displays Down if the port is not connected to any device.

State

If STP (Spanning Tree Protocol) is enabled, this field displays the STP state of the 
port (see 

 for more information). 

If STP is disabled, this field displays FORWARDING if the link is up, otherwise, it 
displays STOP. 

LACP

This fields displays whether LACP (Link Aggregation Control Protocol) has been 
enabled on the port.

TxPkts

This field shows the number of transmitted frames on this port.

RxPkts

This field shows the number of received frames on this port.

Errors

This field shows the number of received errors on this port.

Tx KB/s

This field shows the number of kilobytes per second transmitted on this port.

Rx KB/s

This field shows the number of kilobytes per second received on this port.

Up Time

This field shows the total amount of time in hours, minutes and seconds the port 
has been up.

Clear Counter

Enter a port number and then click Clear Counter to erase the recorded statistical 
information for that port, or select Any to clear statistics for all ports.