ZyXEL Communications ZyWALL5UTM 4.0 User Manual

ZyWALL 5/35/70 Series User’s Guide

475 

Chapter 30 Logs Screens

Figure 241   Reports

Note: Enabling the ZyWALL’s reporting function decreases the overall throughput by 

about 1 Mbps.

The following table describes the labels in this screen.

Table 167   Reports

Collect Statistics Select the check box and click Apply to have the ZyWALL record report data.

Send Raw 

Traffic Statistics 

to Syslog Server 

for Analysis 

Select the check box and click Apply to have the ZyWALL send unprocessed traffic 

statistics to a syslog server for analysis. 
You must have the syslog server already configured in the Log Settings screen.

Apply

Click Apply to save your changes back to the ZyWALL.

Reset

Click Reset to begin configuring this screen afresh.

Interface

Select on which interface (LAN, DMZ or WLAN) the logs will be collected. The logs 

on the DMZ, LAN or WLAN IP alias 1 and 2 are also recorded.

Report Type

Use the drop-down list box to select the type of reports to display.
Web Site Hits displays the web sites that have been visited the most often from the 

LAN and how many times they have been visited.
Protocol/Port displays the protocols or service ports that have been used the most 

and the amount of traffic for the most used protocols or service ports.
Host IP Address displays the LAN, DMZ or WLAN IP addresses to and /or from 

which the most traffic has been sent and how much traffic has been sent to and from 

those IP addresses.

Refresh

Click Refresh to update the report display. The report also refreshes automatically 

when you close and reopen the screen. 

Flush

Click Flush to discard the old report data and update the report display.

Note: All of the recorded reports data is erased when you turn off the ZyWALL.