ZyXEL Communications ZyWALL5UTM 4.0 User Manual

ZyWALL 5/35/70 Series User’s Guide

521 

Chapter 34 WAN and Dial Backup Setup

The following table describes the fields in this menu.

Table 196   Menu 11.3.3: Remote Node Script

Active 

Press [SPACE BAR] and then [ENTER] to select either Yes to enable the AT strings or 

No to disable them.

Set 1-6: 

Expect 

Enter an Expect string to match. After matching the Expect string, the ZyWALL returns 

the string in the Send field.

Set 1-6: 

Send 

Enter a string to send out after the Expect string is matched.

Move the cursor to the field Edit Filter Sets in menu 11.3, and then press [SPACE BAR] to 
set the value to Yes. Press [ENTER] to open Menu 11.3.4 - Remote Node Filter. 

Use menu 11.3.4 to specify the filter set(s) to apply to the incoming and outgoing traffic 
between this remote node and the ZyWALL to prevent certain packets from triggering calls. 
You can specify up to four filter sets separated by commas, for example, 1, 5, 9, 12, in each 
filter field. Note that spaces are accepted in this field. Please refer to 

 

for more information on defining the filters. 

Figure 280   Menu 11.3.4: Remote Node Filter

Menu 11.3.4 - Remote Node Filter

Input Filter Sets:
  protocol filters=
    device filters=
Output Filter Sets:
  protocol filters=
    device filters=
Call Filter Sets:
  protocol filters=
    device filters=

     Enter here to CONFIRM or ESC to CANCEL: