ZyXEL Communications ZyWALL5UTM 4.0 User Manual

ZyWALL 5/35/70 Series User’s Guide

Chapter 47 Firmware and Configuration File Maintenance

622

Figure 383   Menu 24.7.2 As Seen Using the Console Port 

Menu 24.7.2 - System Maintenance - Upload System Configuration File

To upload system configuration file:     
1. Enter "y" at the prompt below to go into debug mode.     
2. Enter "atlc" after "Enter Debug Mode" message.     
3. Wait for "Starting XMODEM upload" message before activating         
   Xmodem upload on your terminal.     
4. After successful firmware upload, enter "atgo" to restart  
   the system.     

Warning:     
1. Proceeding with the upload will erase the current        
configuration file.     
2. The system's console port speed (Menu 24.2.2) may change when it is 
restarted; please adjust your terminal's speed accordingly. The password 
may change (menu 23), also.     
3. When uploading the DEFAULT configuration file, the console        
port speed will be reset to 9600 bps and the password to "1234".
                           
         Do You Wish To Proceed:(Y/N)

2 After the "Starting Xmodem upload" message appears, activate the Xmodem protocol on 

your computer. Follow the procedure as shown previously for the HyperTerminal 
program. The procedure for other serial communications programs should be similar.

3 Enter “atgo” to restart the ZyWALL.

Click Transfer, then Send File to display the following screen.

Figure 384   Example Xmodem Upload

After the configuration upload process has completed, restart the ZyWALL by entering 
“atgo”.