ZyXEL Communications P-6600HW-Tx v3 User Manual

 Chapter 15 Bandwidth Management

P-660HW-Tx v3 User’s Guide

You must use the Bandwidth Management Summary screen to enable bandwidth 
management on an interface before you can configure rules for that interface.
Click Advanced > Bandwidth MGMT > Rule Setup to open the following screen.

Figure 132   Bandwidth Management: Rule Setup

The following table describes the labels in this screen.  

Table 84   Bandwidth Management: Rule Setup

Rule Setup

Direction 

Select the direction of traffic to which you want to apply bandwidth management.

Service 

Select a service for your rule or you can select User Defined to go to the screen 

where you can define your own.

Priority

Select a priority from the drop down list box. Choose High, Mid or Low.

Bandwidth (kbps)

Specify the maximum bandwidth allowed for the rule in kbps. The 

recommendation is a setting between 20 kbps and 20000 kbps for an individual 

rule. 

Add

Click this button to add a rule to the following table.

To X Interface

#

This is the number of an individual bandwidth management rule.

Active

This displays whether the rule is enabled. Select this check box to have the 

ZyXEL Device apply this bandwidth management rule. 
Enable a bandwidth management rule to give traffic that matches the rule priority 

over traffic that does not match the rule.
Enabling a bandwidth management rule also allows you to control the maximum 

amounts of bandwidth that can be used by traffic that matches the rule.

Rule Name

This is the name of the rule.

Destination Port 

This is the port number of the destination. 0 means any destination port.

Priority

This is the priority of this rule. 

Bandwidth (kbps)

This is the maximum bandwidth allowed for the rule in kbps.