ZyXEL Communications P-660HN-T1H User Manual

 Chapter 12 Static Route

P-660HN-T1H User’s Guide

Use this screen to configure the required information for a static route. Select a 
static route index number and click Edit. The screen shown next appears.

Figure 78   Advanced > Static Route: Edit

The following table describes the labels in this screen. 

Modify

Click the Edit icon to go to the screen where you can set up a static route 
on the ZyXEL Device.

Click the Remove icon to remove a static route from the ZyXEL Device. A 
window displays asking you to confirm that you want to delete the route. 

Apply

Click this to save your changes.

Cancel

Click this to restore your previously saved settings.

Table 53   Advanced > Static Route

Table 54   Advanced > Static Route: Edit

Static Route Setup
Destination IP 
Address

This parameter specifies the IP network address of the final destination.  
Routing is always based on network number. If you need to specify a 
route to a single host, use a subnet mask of 255.255.255.255 in the 
subnet mask field to force the network number to be identical to the host 
ID.

IP Subnet 
Mask 

Enter the IP subnet mask here.

Gateway IP 
Address

Enter the IP address of the gateway. The gateway is a router or switch on 
the same network segment as the device's LAN or WAN port. The 
gateway helps forward packets to their destinations.

Back

Click this to return to the previous screen without saving.

Apply

Click this to save your changes.

Cancel

Click this to restore your previously saved settings.