ZyXEL Communications P-335WT User Manual
P-335 Series User’s Guide
287
Chapter 28 Remote Node Configuration
28.2.2.2 Nailed-Up Connection
A nailed-up connection is a dial-up line where the connection is always up regardless of traffic
demand. The Prestige does two things when you specify a nailed-up connection. The first is
that idle timeout is disabled. The second is that the Prestige will try to bring up the connection
when turned on and whenever the connection is down. A nailed-up connection can be very
expensive for obvious reasons.
demand. The Prestige does two things when you specify a nailed-up connection. The first is
that idle timeout is disabled. The second is that the Prestige will try to bring up the connection
when turned on and whenever the connection is down. A nailed-up connection can be very
expensive for obvious reasons.
Do not specify a nailed-up connection unless your telephone company offers flat-rate service
or you need a constant connection and the cost is of no concern.
or you need a constant connection and the cost is of no concern.
The following table describes the fields not already described in
.
Table 118 Fields in Menu 11.1 (PPPoE Encapsulation Specific)
FIELD
DESCRIPTION
Service Name
If you are using PPPoE encapsulation, then type the name of your PPPoE service
here. Only valid with PPPoE encapsulation.
Authen
This field sets the authentication protocol used for outgoing calls.
Options for this field are:
•
Options for this field are:
•
CHAP/PAP - Your Prestige will accept either CHAP or PAP when requested by
this remote node.
•
CHAP - accept CHAP only.
•
PAP - accept PAP only.
Telco Option
Allocated Budget The field sets a ceiling for outgoing call time for this remote node. The default for
this field is 0 meaning no budget control.
Period(hr)
This field is the time period that the budget should be reset. For example, if we are
allowed to call this remote node for a maximum of 10 minutes every hour, then the
Allocated Budget is (10 minutes) and the Period(hr) is 1 (hour).
Schedules
You can apply up to four schedule sets here. For more details please refer to the
Call Schedule Setup chapter.
Nailed-Up
Connection
This field specifies if you want to make the connection to this remote node a nailed-
up connection. More details are given earlier in this section.
Session Options
Idle Timeout
Type the length of idle time (when there is no traffic from the Prestige to the remote
node) in seconds that can elapse before the Prestige automatically disconnects the
PPPoE connection. This option only applies when the Prestige initiates the call.
28.2.3 PPTP Encapsulation
If you change the Encapsulation to PPTP in menu 11.1, then you will see the next screen.
Please see the appendix for information on PPTP.
Please see the appendix for information on PPTP.