ZyXEL Communications 100 Series User Manual

 Chapter 12 Policy and Static Routes

ZyWALL USG 100/200 Series User’s Guide

Click Network > Routing to open the Policy Route screen. Then click

 

the Add or Edit icon 

to open the Policy Route Edit screen. Use this screen to configure or edit a policy route.

See 

 for an example of NAT loopback.

Figure 195   Network > Routing > Policy Route > Edit

The following table describes the labels in this screen.  

Table 90   Network > Routing > Policy Route > Edit

Configuration

Enable

Select this to activate the policy.

Description

Enter a descriptive name of up to 31 printable ASCII characters for the policy.

Criteria

User

Select a user name or user group from which the packets are sent. Select Create 
Object to configure a new user account (see 

 for 

details).

Incoming 
Interface

Click Change... to select an interface or VPN tunnel through which the incoming 
packets are received.

Source Address

Select a source IP address object or select Create Object to configure a new one.

Destination 
Address

Select a destination IP address object or  select Create Object to configure a new 
one. If the next hop is a dynamic VPN tunnel and you enable Auto Destination 
Address, the ZyWALL uses the local network of the peer router that initiated an 
incoming dynamic IPSec tunnel as the destination address of the policy instead of 
your configuration here.