ZyXEL Communications 100 Series User Manual

 Chapter 35 User/Group

ZyWALL USG 100/200 Series User’s Guide

The following table describes the labels in this screen.  

Access users cannot use the Web configurator to browse the configuration of the ZyWALL. 
Instead, when access users log in to the ZyWALL (forced in the screen as shown in 

 or otherwise), the following screen appears.

Figure 447   Web Configurator for Non-Admin Users

Table 197   Object > User/Group > Setting > Add/Edit

Enable

Select this if you want this condition to be active.

Description

Enter a description for this condition. It can be up to 60 printable ASCII characters 
long.

Authentication

Select whether users must log in (force) or whether users do not have to log in 
(skip) when this condition is checked and satisfied.

Source Address

Select a source IP address object or select Create Object to configure a new one.
Select any if this condition applies to traffic from all source addresses.

Destination 
Address

Select the destination address of traffic to which this condition applies or select 
Create Object to configure a new one. Select any if this condition applies to traffic 
from all destination addresses.

Schedule

Select the schedule object that specifies when this condition applies or select 
Create Object to configure a new one (see 

 for details). 

Select none if this condition always applies.

OK

Select this to save your changes and return to the previous screen.

Cancel

Select this to return to the previous screen without saving any changes.