ZyXEL Communications 1001H User Manual
P100IH ISDN Router
NAT
4-7
Address
Mapping Set=
Mapping Set=
A NAT Server Set is a list of LAN side servers mapped to external ports
(similar to the old SUA menu 15.1 before). You may enter any server set
number up to 10, but the first one is used foe SUA only.
(similar to the old SUA menu 15.1 before). You may enter any server set
number up to 10, but the first one is used foe SUA only.
4.5 Configuring
NAT
To configure NAT, enter 15 from the Main Menu to bring up the following screen.
Figure 4-6 Menu 15 NAT Setup
4.5.1
Address Mapping Sets and NAT Server Sets:
Use the Address Mapping Sets menus and submenus to create the mapping table used to assign global
addresses to machines on the LAN. Each remote node must specify which NAT Address Mapping Set to
use. You can see the NAT Address Mapping sets in Menu 15.1. Set 255 is used for SUA. When you select
Full Feature in menu 4 or 11.3, the SMT will use Set 1, which supports all mapping types as outlined in
Table 4-3
addresses to machines on the LAN. Each remote node must specify which NAT Address Mapping Set to
use. You can see the NAT Address Mapping sets in Menu 15.1. Set 255 is used for SUA. When you select
Full Feature in menu 4 or 11.3, the SMT will use Set 1, which supports all mapping types as outlined in
Table 4-3
. When you select SUA Only, the SMT will use the pre-configured Set 255 (read only) – see
section 4.2
.
The NAT Server set is a list of LAN side servers mapped to external ports. To use this set (one set for the
P312), a server rule must be set up inside the NAT Address Mapping set. Please see section 4.5.2 for further
information on these menus.
P312), a server rule must be set up inside the NAT Address Mapping set. Please see section 4.5.2 for further
information on these menus.
Enter 1 to bring up Menu 15.1 – Address Mapping Sets.
Menu 15 – NAT Setup
1. Address Mapping Sets
2. NAT Server Sets
2. NAT Server Sets
Enter Menu Selection Number: