ZyXEL Communications ZyXEL G-560 User Manual

Page of 144
ZyXEL G-560 User’s Guide
Appendix B Wireless LANs
123
A large Fragmentation Threshold is recommended for networks not prone to interference 
while you should set a smaller threshold for busy networks or networks that are prone to 
interference.
If the Fragmentation Threshold value is smaller than the RTS/CTS value (see previously) 
you set then the RTS (Request To Send)/CTS (Clear to Send) handshake will never occur as 
data frames will be fragmented before they reach RTS/CTS size.
IEEE 802.11g Wireless LAN
IEEE 802.11g is fully compatible with the IEEE 802.11b standard.  This means an IEEE 
802.11b adapter can interface directly with an IEEE 802.11g access point (and vice versa) at 
11 Mbps or lower depending on range. IEEE 802.11g has several intermediate rate steps 
between the maximum and minimum data rates. The IEEE 802.11g data rate and modulation 
are as follows:
Table 29   IEEE802.11g
DATA RATE (MBPS)
MODULATION
1
DBPSK (Differential Binary Phase Shift Keyed)
2
DQPSK (Differential Quadrature Phase Shift Keying)
5.5 / 11
CCK (Complementary Code Keying) 
6/9/12/18/24/36/48/54
OFDM (Orthogonal Frequency Division Multiplexing) 
IEEE 802.1x
In June 2001, the IEEE 802.1x standard was designed to extend the features of IEEE 802.11 to 
support extended authentication as well as providing additional accounting and control 
features. It is supported by Windows XP and a number of network devices. Some advantages 
of IEEE 802.1x are:
• User based identification that allows for roaming.
• Support for RADIUS (Remote Authentication Dial In User Service, RFC 2138, 2139) for 
centralized user profile and accounting management on a network RADIUS server. 
• Support for EAP (Extensible Authentication Protocol, RFC 2486) that allows additional 
authentication methods to be deployed with no changes to the access point or the wireless 
stations. 
RADIUS
RADIUS is based on a client-server model that supports authentication, authorization and 
accounting. The access point is the client and the server is the RADIUS server. The RADIUS 
server handles the following tasks: