ZyXEL Communications 202H User Manual

Prestige 202H User’s Guide 

6-6 

Ethernet Setup 

Primary DNS 
Server 

Secondary 
DNS Server 

Enter the IP addresses of the DNS servers. The DNS servers are passed 
to the DHCP clients along with the IP address and the subnet mask. 

 

Remote 
DHCP Server 

If Relay is selected in the DHCP field above, then enter the IP address of 
the actual, remote DHCP server here. 

 

 

Use the instructions in the following table to configure TCP/IP parameters for the LAN port. 

TCP/IP Setup 

 

 

IP Address  Enter the IP address of your router in dotted decimal notation. 

192.168.1.1 

(default) 

IP Subnet Mask  Your router will automatically calculate the subnet mask based on the IP 

address that you assign. Unless you are implementing subnetting, use 
the subnet mask computed by the router. 

255.255.255.0

RIP Direction  Press [SPACE BAR] to select the RIP direction from Both/None/In Only/ 

Out Only. 

Both (default)

Version  Press [SPACE BAR] to select the RIP version from RIP-1/RIP-2B/ RIP-

2M. 

RIP-1 (default)

Edit IP Alias  The Prestige supports three logical LAN interfaces via its single physical 

Ethernet interface with the Prestige itself as the gateway for each LAN 
network. Press [SPACE BAR] to select Yes and then press [ENTER] to 
display menu 3.2.1 

Yes 

 

When you have completed this menu, press [ENTER] at the prompt “Press ENTER to Confirm…” to save 
your configuration, or press [ESC] at any time to cancel. 

 

IP Alias allows you to partition a physical network into different logical networks over the same Ethernet 
interface. The router supports three logical LAN interfaces via its single physical Ethernet interface with the 
router itself as the gateway for each LAN network.