ZyXEL Communications 200 Series User Manual

Chapter 4 Wizard Setup

ZyWALL USG 100/200 Series User’s Guide

Click the Advanced radio button as shown in 

 to display the following 

screen.

Figure 39   VPN Advanced Wizard: Step 2 

The following table describes the labels in this screen.

Table 18   VPN Advanced Wizard: Step 2

Remote 
Gateway

Name

Type the name used to identify this VPN connection (and VPN gateway). You may 
use 1-31 alphanumeric characters, underscores(

_

), or dashes (-), but the first 

character cannot be a number. This value is case-sensitive.

Secure 
Gateway

Enter the WAN IP address or domain name of the remote IPSec router (secure 
gateway) in the field below to identify the remote IPSec router by its IP address or a 
domain name. Set this field to 0.0.0.0 if the remote IPSec router has a dynamic WAN 
IP address.

My Address 
(interface)

Select an interface from the drop-down list box to use on your ZyWALL.

Authentication 
Method

Pre-Shared 
Key

Type your pre-shared key in this field. A pre-shared key identifies a communicating 
party during a phase 1 IKE negotiation. It is called "pre-shared" because you have to 
share it with another party before you can communicate with them over a secure 
connection. 
Type from 8 to 31 case-sensitive ASCII characters or from 16 to 62 hexadecimal ("0-
9", "A-F") characters. Precede hexadecimal characters with “0x”.
Both ends of the VPN tunnel must use the same pre-shared key. You will receive a 
PYLD_MALFORMED (payload malformed) packet if the same pre-shared key is not 
used on both ends.