Technicolor - Thomson 605 User Manual
Chapter 5
Expert Configuration
E-DOC-CTC-20050429-0104 v1.0
137
It is the responsibility of the network operator to provide end-to-end connectivity
throughout the network on these virtual channels. Due to regional differences or
because of the specific policy of your local operator, specific VPI/VCI values may be
required. In this case, the network operator, ISP or corporate administrator will
provide the correct values.
The VPI can range from 0 to 15, VCI from 32 .. 511.
throughout the network on these virtual channels. Due to regional differences or
because of the specific policy of your local operator, specific VPI/VCI values may be
required. In this case, the network operator, ISP or corporate administrator will
provide the correct values.
The VPI can range from 0 to 15, VCI from 32 .. 511.
QoS Book
The QoS Book table displays following parameters:
Name
:
The name of the new QoS entry.
txctd
:
The name of the Connection Traffic Descriptor (CTD) for the transmit
(upstream) direction.
(upstream) direction.
rxctd
:
The name of the CTD for the receive (downstream) direction.
Interfaces
The Interfaces tab allows you to configure:
Name
:
The name of the ATM interface to be configured.
Destination
:
The WAN destination for this ATM interface. Typically, an ATM phonebook
entry.
entry.
Qos name
:
The name of the Quality of Service (QoS) book entry to apply on this ATM
interface.
interface.
Encapsulation
:
The type of encapsulation to be used for this ATM interface. Choose between:
llc
: Logical Link Control (LLC) / Sub Network Access Protocol (SNAP)
vcmux
: Virtual Channel MUltipleXing (VCMUX).
auto
: the SpeedTouch™ will determine the encapsulation method to use.
Number of retries
:
A number between 0 and 65535. Represents the number of times the
SpeedTouch™ retries to set up a WAN connection before giving up.
SpeedTouch™ retries to set up a WAN connection before giving up.
FCS
:
Enable or disable the inclusion of the Ethernet Frame Check Sequence (FCS) in
the packet header on the WAN side (only used for llc encapsulation for mac).
the packet header on the WAN side (only used for llc encapsulation for mac).
Upper layer protocol
:
Select the Upper Layer Protocol (ULP) for this interface. Choose between:
ip
(for a Routed IPoA interface).
mac
(for a Bridged Ethernet, Routed ETHoA, Bridged PPP over Ethernet
(PPPoE), Routed PPPoE or a PPPoE Relay interface).
ppp
(for a Routed PPP over ATM (PPPoA) interface).
If your SpeedTouch™ is equipped with an ATMF-25.6Mb/s interface, VPI 0 to
7 (included) are cross-connected between the DSL port and the ATMF-
25.6Mb/s port. Unless these cross-connects are deleted using the CLI, these
VPI values (0 ... 7) cannot be used.
7 (included) are cross-connected between the DSL port and the ATMF-
25.6Mb/s port. Unless these cross-connects are deleted using the CLI, these
VPI values (0 ... 7) cannot be used.
This parameter is normally left disabled.