NEC IP8800/S6300 User Manual

Troubleshooting System Failures

2.1

Troubleshooting for IP8800/S6700, IP8800/S6600,
and IP8800/S6300

2.1.1

Troubleshooting Procedure on System Failures

Follow the procedure below when the system failed.

Table 2-1: Troubleshooting System Failures

No.

Failure

Action

• Fume generated from the system
• Unusual odor occurs from the system
• Unusual sound occurs from the system

Execute the steps below immediately.
1. Power off the system.
2. When the power cable is fastened by the slip-off preventive clamp,

remove it from the power cable.

3. For AC power supply, unplug the power cable.

4. For DC power supply, turn off the breaker of power distribution panel

connected to the system.

Shut down operation as described above and then contact the local sales
office.

1. When MC is inserted, first remove the MC then reboot the system by

turning it off and on.

2. When MC is not inserted, reboot the system by turning it off and on.
3. If the same problem still persists after system reboot, replace BCU/CSU/

MSU.

All LEDs on BCU/MSU are OFF

1. Check LED on the power supply and follow the steps below.

(1) If ALARM LED is lit in red on the power supply, replace the power

supply with a new one.

(2) If both POWER LED and ALARM LED are OFF on the power

supply, implement "

." If the

problem is not settled, replace the power supply with LED turned off.

2. If all power supplies are running normally, replace BCU/CSU/MSU.

BCU/CSU/MSU SYSTEM1 LED lit in red or
orange

1. If an error message is output to the system operation panel, take the

action against the corresponding error message in manual "Message Log
Reference."

2. If no error message is output, replace BCU, BSU, CSU, MSU or NIF on

which STATUS LED is lit in red.