Netgear UTM50-100NAS User Manual
ProSecure Unified Threat Management (UTM) Appliance Reference Manual
Virtual Private Networking Using IPsec Connections
7-11
v1.0, January 2010
3. Select the radio buttons and complete the fields and as explained
.
.
Table 7-3. (IPsec) VPN Wizard Settings for a Client-to-Gateway Tunnel
Setting
Description (or Subfield and Description)
About VPN Wizard
This VPN tunnel will connect
to the following peers
to the following peers
Select the VPN Client radio button. The default remote FQDN
(utm_remote.com) and the default local FQDN (utm_local.com) appear
in the End Point Information section of the screen.
(utm_remote.com) and the default local FQDN (utm_local.com) appear
in the End Point Information section of the screen.
Connection Name and Remote IP Type
What is the new Connection
Name?
Name?
Enter a descriptive name for the connection. This name is used to help
you to manage the VPN settings; the name is not supplied to the
remote VPN endpoint.
you to manage the VPN settings; the name is not supplied to the
remote VPN endpoint.
What is the pre-shared key?
Enter a pre-shared key. The key must be entered both here and on the
remote VPN gateway, or the remote VPN client. This key must have a
minimum length of 8 characters and should not exceed 49 characters.
remote VPN gateway, or the remote VPN client. This key must have a
minimum length of 8 characters and should not exceed 49 characters.
This VPN tunnel will use
following local WAN Interface
(dual-WAN port models only)
following local WAN Interface
(dual-WAN port models only)
For the dual-WAN port models only, select one of the two radio buttons
(WAN1 or WAN2) to specify which local WAN interface the VPN tunnel
uses as the local endpoint.
Note: If a dual-WAN port model is configured to function in WAN auto-
rollover mode, after completing the wizard, you must manually update
the VPN policy to enable VPN rollover. For more information, see
(WAN1 or WAN2) to specify which local WAN interface the VPN tunnel
uses as the local endpoint.
Note: If a dual-WAN port model is configured to function in WAN auto-
rollover mode, after completing the wizard, you must manually update
the VPN policy to enable VPN rollover. For more information, see
End Point Information
a
a. Both local and remote endpoints should be defined as either FQDNs or IP addresses. A combination of an IP address and
a FQDN is not supported.
What is the Remote Identifier
Information?
Information?
When you select the Client radio button in the About VPN Wizard
section of the screen, the default remote FQDN (utm_remote.com) is
automatically entered. Use the default remote FQDN or enter another
FQDN.
section of the screen, the default remote FQDN (utm_remote.com) is
automatically entered. Use the default remote FQDN or enter another
FQDN.
What is the Local Identifier
Information?
Information?
When you select the Client radio button in the About VPN Wizard
section of the screen, the default local FQDN (utm_local.com) is
automatically entered. Use the default local FQDN or enter another
FQDN.
section of the screen, the default local FQDN (utm_local.com) is
automatically entered. Use the default local FQDN or enter another
FQDN.
Secure Connection Remote Accessibility
What is the remote LAN IP
Address?
Address?
These fields are masked out for VPN client connections.
What is the remote LAN
Subnet Mask?
Subnet Mask?