Netgear UTM50-100NAS User Manual

3-16

Manually Configuring Internet and WAN Settings

b. Click the Add table button in the rightmost column to add the protocol binding rule to the 

Protocol Binding table. The rule is automatically enabled, which is indicated by the “!” 
status icon that displays a green circle.

 and 

 for each protocol binding rule that you want to add to the Protocol 

Binding table.

d. If not all table entries are enabled, select the table entries that you want to enable, or click 

the Select All table button. Then, click the Enable table button.

Open the WAN2 Protocol Bindings screen and repeat 

 through 

 to set protocol 

bindings for the WAN2 port.

Return to the WAN Mode screen by selecting Network Config > WAN Settings from the 
menu and clicking the WAN Mode tab.

4. Click Apply to save your settings.

Source Network
(continued)

Group 1–Group 8 If this option is selected, the rule is applied to the devices 

that are assigned to the selected group. 
Note: You may also assign a customized name to a group 
(see 

).

Destination 
Network

The destination network settings determine which Internet locations (based on 
their IP address) are covered by the rule. Select one of the following options 
from the pull-down menu:

Any

All Internet IP address. 

Single address

In the Start Address field, enter the IP address that is 
covered by the rule.

Address range

In the Start Address field and End Address field, enter the 
IP addresses for the range that is covered by the rule.