Polycom A200 User Manual
Configuration Guide
PN: 1725-36080-001_J.doc
28
CLI Commands to Set Up Subnet Roaming
Commands for the master switch (the Aruba 800)
Configure terminal
ip
ip
default-gateway
<ip_addr of router>
ap location 1.1.0 (#ap connected to 800)
lms-ip <ip_addr of 800 switch>
ap location 1.2.0 (#ap connected to 6000)
lms-ip <ip_addr of 6000 switch>
ap location 1.2.0 (#ap connected to 6000)
lms-ip <ip_addr of 6000 switch>
ip route 224.0.0.0 255.0.0.0 <ip_addr of SpectraLink
gateway>
exit
write
exit
write
mem
Commands for the local switch (the Aruba 6000)
The AP’s IP address must be on the same subnet as the switch.
Configure terminal
masterip <ip address of the master >
interface loopback
ip address <ip_addr of the 6000>
vlan
masterip <ip address of the master >
interface loopback
ip address <ip_addr of the 6000>
vlan
1
interface vlan 1
ip
address
<ip_addr of the 6000> <netmask>
interface fastethernet
<port>
switchport access vlan 1
(only if the port is an
access
port)
trusted
no
no
shut
!
ip
ip
default-gateway
<ip_addr of router>
!
exit
write
exit
write
mem
After the master switch IP address and the local switch IP address are
configured on the local switch, the switch needs to be rebooted prior
to use.
configured on the local switch, the switch needs to be rebooted prior
to use.