Polycom A6000 User Manual

 

 Configuration Guide 

PN: 1725-36080-001_J.doc 

10 

Assigning an IP to the Mobility Controller 

1.  Connect to the switch via the CLI. 
2.  Login with the configured username and password, 

 

in this example. 

3.  Type 

 at the 

>

 prompt. 

4.  Type the enable password, 

 in this example. 

5.  Type 

 at the # prompt. 

6.  Create the VLAN for the voice (vlan 25) using the VLAN 

command: 

(Aruba) (config) #vlan 25

7.  Create the VLAN interface. 

(Aruba) (config) #interface vlan 25

 

8.  Assign the IP address to the interface. 

(Aruba) (config-subif)#ip address 10.168.10.2 
255.255.255.0

 

9.  Create the loopback interface and assign an IP address to the 

loopback. For more information about the loopback interface refer 
to the user guide. 

(Aruba) (config) #interface loopback

 

(Aruba) (config-loop)#ip address 10.168.10.1

 

Switch IP Address is Modified. Switch should be 
rebooted now 
(Aruba) (config-loop)#!

 

(Aruba) (config) #ip default-gateway 10.168.10.10

 

10.  Assign a physical interface to the VLAN. In this example, the 

interface connecting to the network is a trunk interface. Configure 
the mode on the interface to a trunk mode. 

(Aruba) (config) #interface fastethernet 1/0

 

(Aruba) (config-if)#trusted

 

(Aruba) (config-if)#no shutdown

 

(Aruba) (config-if)#switchport mode trunk

 

(Aruba) (config-if)#switchport trunk allowed vlan add 
10,25

  

(Aruba) (config-if)#!

 

(Aruba) (config)# 

11.  Ping the default gateway from the switch’s console.  
12.  Ping the switch’s IP address from the management station.