Black Box 8-/16-/24-Port 10/100 PoE PSE Web Smart Switch User Manual
8-/16-/24-Port 10/100 PoE PSE Web Smart Switch
724-746-5500 l www.blackbox.com
16
Case 3: The same VLAN members can be at different switches with the same VID (See Figure 3-6).
Figure 3-6. Attribute-based VLAN diagram.
3.6 Set IP Address, Subnet Mask, and Default Gateway IP Address
First, either configure your PC IP address or change IP address of the switch. Next, change the IP address of default
gateway and subnet mask.
For example, your network address is 10.1.1.0, and subnet mask is 255.255.255.0. You can change the switch’s default
IP address 192.168.2.1 to 10.1.1.1 and set the subnet mask to 255.255.255.0. Then, choose your default gateway, for
example, 10.1.1.254.
gateway and subnet mask.
For example, your network address is 10.1.1.0, and subnet mask is 255.255.255.0. You can change the switch’s default
IP address 192.168.2.1 to 10.1.1.1 and set the subnet mask to 255.255.255.0. Then, choose your default gateway, for
example, 10.1.1.254.
Default Value
LPB708A/LPB716A Your Network Setting
IP Address
192.168.2.1 10.1.1.1
Subnet
255.255.255.0 255.255.255.0
Default Gateway
192.168.2.254 10.1.1.254
After completing these settings in the switch, it will reboot so the configuration will take effect. After this step, you can
operate the management through the network.
NOTE: There are no default DNS settings. DNS addresses are assigned by the network administrator.
Before you communicate with the switch, finish the configuration of the IP address or know the IP address of the switch.
Then, follow the procedures listed next.
1. Set up a physical path between the switch and a PC by a qualified UTP CAT5 cable with an RJ-45 connector.
Before you communicate with the switch, finish the configuration of the IP address or know the IP address of the switch.
Then, follow the procedures listed next.
1. Set up a physical path between the switch and a PC by a qualified UTP CAT5 cable with an RJ-45 connector.
VLAN 1
VLAN 2
VLAN 3