Cisco Systems 511 User Manual
Chapter 4 Installing Hardware Options
Working with Hard Disk Drives
4-14
Cisco Content Engine 511 and 566 Hardware Installation Guide
OL-5756-01
Installing a Hard Disk Drive in the CE-566
To install a SCSI hard disk drive in CE-566, complete the following steps.
Note
All hard disk drives being used in the Content Engine should have the same
throughput speed rating. Mixing hard disk drives with different speed ratings will
cause all hard disk drives to operate at the lower throughput speed.
throughput speed rating. Mixing hard disk drives with different speed ratings will
cause all hard disk drives to operate at the lower throughput speed.
Note
If your Content Engine has only one hard disk drive, install it in the left drive bay.
Note
To maintain proper system cooling, do not operate the Content Engine for more
than 10 minutes without either a hard disk drive or a filler panel installed in
each bay.
than 10 minutes without either a hard disk drive or a filler panel installed in
each bay.
Step 1
Inspect the new drive for any signs of damage.
Step 2
Review the information in the
, and the
Step 3
Power down the Content Engine and peripheral devices, and disconnect the power
cord and all external cables.
cord and all external cables.
Step 4
.)
Step 5
Slide the drive tray out of the Content Engine.
Step 6
Position the hard disk drive on the tray. (See
Step 7
Secure the hard disk drive using screws.
Step 8
Slide the tray back into the Content Engine.
Step 9
Connect the power and signal cables to the drive.
Step 10
Replace the bezel.