Panasonic PT-DW730EL User Manual
Technical Information
100 - ENGLISH
Appendix
REMOTE 2 IN terminal
It is possible to control the projector remotely (by external contact) from a control panel located away from
the projector where remote control signals cannot reach. Use the <REMOTE 2 IN> terminal on the side of the
projector to connect to the control panel.
Remote control
External control
Remote control/External control
Standby
ON
LAMP
RGB1
VIDEO
RGB2
S-VIDEO
DVI-D
Projector set up in a meeting room
Control panel located in a different room
■Pin assignments and signal names
D-Sub 9-pin (Outside view)
Pin No.
Signal name
Open (H)
Short (L)
(1)
(5)
(6)
(9)
(1)
GND
–
GND
(2)
POWER
OFF
ON
(3)
RGB1
Other
RGB1
(4)
RGB2
Other
RGB2
(5)
VIDEO
Other
VIDEO
(6)
S-VIDEO
Other
S-VIDEO
(7)
DVI-D
Other
DVI-D
(8)
SHUTTER
OFF
ON
(9)
RST/SET
Controlled by remote
control
Controlled by
external contact
Attention
z
When controlling, make sure to short-circuit pins
(1) and (9).
z
When pins
(1) and (9) are short-circuited, the following buttons on the control panel and the remote control
cannot be used.
The POWER ON <
> button, the STANDBY <
> button, the <SHUTTER> button, and the corresponding
RS-232C commands and network functions cannot be used either.
z
When pins
(1) and (9) are short-circuited, do not short-circuit any pins from (3) to (7) with pin (1). The following
buttons on the control panel and the remote control cannot be used.
The POWER ON <
> button, the STANDBY <
> button, the <RGB1> button, the <RGB2> button, the
<DVI-D> button, the <VIDEO> button, the <S-VIDEO> button, the <SHUTTER> button, and the corresponding
RS-232C commands and network functions cannot be used either.
Note
z
For pin
(2) to pin (8) settings, you can make changes if you set [REMOTE2 MODE] to [USER]. (
page 64)