Panasonic PT-DW730EL User Manual

 

z

When remove the batteries, perform the steps 

in the reverse order.

When you use the system with multiple projectors, 

you can operate all the projectors simultaneously or 

each projector individually using single remote control, 

if a unique ID number is assigned to each projector.

After setting the ID number of the projector, set same 

ID number on the remote control. 

■ How to set

 

z

Since setting of the ID number on the remote 

control can be performed even without the projector, 

do not press the <ID SET> button carelessly. If the 

number (<0> - <9>) button is not pressed within five 

seconds after the <ID SET> button is pressed, the 

ID number returns to that before pressing the <ID 

SET> button.

 

z

The ID number set on the remote control will 

be stored unless it is set again. However, it will 

be erased if the remote control is left with dead 

batteries. Set the same ID number again when the 

batteries are replaced. 

 

z

Set the ID number of the projector from the 

[PROJECTOR SETUP] menu  [PROJECTOR ID] 

(



 page 61). 

When you use the system with multiple projectors, 

configure the units as in the following figure. Use a 

commercial M3 stereo mini jack cable and connect 

the other devices to the <REMOTE 1 IN>/<REMOTE 

1 OUT> terminals of the projector. 

It is effective to use the remote control in a place 

where an obstacle stands in the light path or where 

devices are susceptible to the outside light.

Connecting terminals

Connect to the 

secondary projector

M3 stereo mini jack cable 

(commercial)

Remote 

control

Connect to the remote control 

wired terminal

 

z

Use a cable that is 15 m or shorter, with 2 core 

shield. The remote control may not operate when 

the length of the cable exceeds 15 m or when the 

shielding of the cable is inadequate.