Panasonic PT-DW730EL User Manual

1)  Press the STANDBY < > button. 
2)   Press the ◀▶ buttons to select [OK], 

 

z

Projection of the image will stop, and the Power 

indicator <STANDBY (RED)/ON (GREEN)> on 

the projector lights in orange. 

(The fan keeps running.) 

z

In the cooling state of the luminous lamp after the 

power is turned off, the lamp may not light up even 

if the power is turned on. To light up the lamp, turn 

on the power again after the luminous lamp goes 

into standby status. Turning on the power while the 

lamp is still hot may shorten the lamp life. 

z

(When [STANDBY MODE] is set to [NORMAL]) 

If [STANDBY MODE] (



 page 63) is set to [ECO], 

the power consumption in the standby mode can 

be reduced.

Even if you turn the <MAIN POWER> switch [OFF] 

during projection or just after the lamp turns off, the 

cooling fan will continue to rotate using internally 

stored power. In cases where the <MAIN POWER> 

switch is not easily accessible, such as during ceiling 

mount, you can safely turn off the power by using 

the power breaker switch. This function also works 

if a power outage occurs or if the power cable is 

accidentally disconnected from the outlet right after 

turning off the power.

 

z

If projection was stopped by turning off the power 

breaker switch and you turn on the power breaker 

again, the power indicator <STANDBY (RED)/ON 

(GREEN)> will light in green and projection will 

start again.

 

z

When the lamp has been cooled by the direct 

power off function, it sometimes takes longer than 

usual for the lamp to light up again.

 

z

Confirm that the fan has stopped before packing 

the projector to transport or store. 

STANDBY(RED)/

   ON(GREEN)

LAMP

TEMP

FILTER