Benq MX764 User Manual
Operation
22
Adjusting the projected image
Adjusting the projection angle
The projector is equipped 4 adjuster feet. These adjusters change the image height and
projection angle. To adjust the projector:
projection angle. To adjust the projector:
Screw the rear adjuster feet to fine-tune the
horizontal angle.
horizontal angle.
To retract the feet, screw the adjuster feet in a
reverse direction.
reverse direction.
If the projector is not placed on a flat surface or
the screen and the projector are not
perpendicular to each other, the projected image
becomes trapezoidal. To correct this situation,
see
the screen and the projector are not
perpendicular to each other, the projected image
becomes trapezoidal. To correct this situation,
see
for details.
Auto-adjusting the image
In some cases, you may need to optimize the picture quality. To do this, press AUTO on the
projector or remote control. Within 3 seconds, the built-in Intelligent Auto Adjustment
function will re-adjust the values of Frequency and Clock to provide the best picture quality.
projector or remote control. Within 3 seconds, the built-in Intelligent Auto Adjustment
function will re-adjust the values of Frequency and Clock to provide the best picture quality.
The current source information will be displayed in the corner of the screen for 3 seconds.
This function is only available when PC signal (analog RGB) is selected.
Fine-tuning the image size and clarity
Do not look into the lens while
the lamp is on. The strong light
from the lamp may cause
damage to your eyes.
Be careful when you press the
quick-release button as it is
close to the exhaust vent where
hot air comes from.
the lamp is on. The strong light
from the lamp may cause
damage to your eyes.
Be careful when you press the
quick-release button as it is
close to the exhaust vent where
hot air comes from.
1.
Adjust the projected image to the size
that you need using the zoom ring.
that you need using the zoom ring.
2.
Sharpen the image by rotating the
focus ring.
focus ring.