Runco 1080p User Manual
36
Runco VX-44d/-55d Owner’s Operating Manual
PRE
L
IMINAR
Y
Connecting to AC Power
The VX-44d/-55d system includes two (2) AC power cords (one each for the DHD
Controller and projector).
Controller and projector).
DHD Controller: Plug the female end of one power cord into the AC receptacle on the
rear of the DHD Controller. Connect the other end to your AC power source
(100 to 240 VAC).
rear of the DHD Controller. Connect the other end to your AC power source
(100 to 240 VAC).
Projector: Similarly connect the VX-44d/-55d to a nearby AC outlet. The input voltage to
a VX-44d must be between 100 and 240 VAC. The input voltage to a VX-55d must be
between 200 and 240 VAC.
a VX-44d must be between 100 and 240 VAC. The input voltage to a VX-55d must be
between 200 and 240 VAC.
The LED status window displays an active pattern of segments to
indicate the projector is changing its state from powered down to
powered up. “--” appears in the display when the projector is
ready to be turned on.
indicate the projector is changing its state from powered down to
powered up. “--” appears in the display when the projector is
ready to be turned on.
AutoScope Lens Motor: With AutoScope-equipped projectors, a third power cord is
provided for the lens motor. Plug the female end of the AC power cord into the AC
receptacle on the rear of the lens motor assembly. Connect the other end to a 110 VAC
power source.
provided for the lens motor. Plug the female end of the AC power cord into the AC
receptacle on the rear of the lens motor assembly. Connect the other end to a 110 VAC
power source.
When an external IR receiver is connected to the wired IR input, the
built-in IR sensor on the DHD Controller is disabled.
built-in IR sensor on the DHD Controller is disabled.
Note
➤
The input voltage to the AutoScope lens motor must be between
100 and 120 VAC. Do not connect the AutoScope lens motor
to a 200-240 VAC power source!
100 and 120 VAC. Do not connect the AutoScope lens motor
to a 200-240 VAC power source!
Caution