Runco 1080p User Manual
Runco VX-44d/-55d Owner’s Operating Manual
81
PRE
L
IMINAR
Y
13. Press ENTER to accept the change. This adds the new lamp serial number to the
Lamp History menu and resets the Lamp Hours timer to “0.” Lamp Mode and Lamp
Limit remain as they were for the previous lamp and can be changed at any time.
Limit remain as they were for the previous lamp and can be changed at any time.
Figure 5-5. Recording the Serial Number of a New Lamp
Filter Replacement
Whenever you replace the lamp – or more often if the projector is installed in an extremely
dusty environment – you should also replace the two filters located at the front and right
side of the projector.
dusty environment – you should also replace the two filters located at the front and right
side of the projector.
1.
Loosen the six screws holding right side filter access
panel in place. Then, remove the panel.
panel in place. Then, remove the panel.
2.
Loosen the two screws holding front filter access
panel in place. Then, remove the panel.
panel in place. Then, remove the panel.
3.
Pull the filters out of the projector and discard. Do
not reuse filters.
not reuse filters.
4.
Insert the new filters with the wired side in.
5.
Replace the filter access panels and tighten the
screws to secure them.
screws to secure them.
Always record the serial number of a new lamp. Do this only if you
have just installed a new lamp. This will ensure that the lamp timer
is not reset on an old lamp and that the number of hours logged on
the lamp is accurate.
have just installed a new lamp. This will ensure that the lamp timer
is not reset on an old lamp and that the number of hours logged on
the lamp is accurate.
Lamp
Hours
147
Lamp
S/N
123456789
1. Lamp
Message
2. Lamp
Limit
1000
3. Lamp
Mode
Power
4. Power
500
5. Intensity
0
6.
RVR 3
7.
Lamp History
8.
Change Lamp
9. Reserved
Lamp Adjust
Note
Front Filter Access Cover
Side Filter Access Cover