Runco VX-22D User Manual
60
Runco VX-22d Owner’s Operating Manual
PRE
L
IMINAR
Y
6.
Install the new lamp module.
7.
Replace the lamp cover and re-tighten all
screws.
screws.
5.2
Filter Replacement
Filter Replacement
Whenever you replace the lamp – or more often if the projector is installed in an extremely
dusty environment – you should also replace the filter located at the right side of the
projector.
dusty environment – you should also replace the filter located at the right side of the
projector.
1.
Loosen the four captive screws
holding the filter access panel in
place. Then, remove the panel.
holding the filter access panel in
place. Then, remove the panel.
2.
Pull the filter out of the projector
and discard. Do not reuse filters.
and discard. Do not reuse filters.
3.
Insert the new filter with the pleats
facing in and the foam-covered
side facing out.
facing in and the foam-covered
side facing out.
4.
Replace the filter access panel and
tighten the screws to secure it.
tighten the screws to secure it.
Side Filter
Access Panel