Sanyo PLC-WL2503A User Manual

To ensure safe operation, please observe the following precautions :

  ●  Use two (2) AAA or LR03 type alkaline batteries.

  ●  Always replace batteries in sets.

  ●  Do not use a new battery with a used battery.

  ●  Avoid contact with water or liquid.

  ●  Do not expose the remote control to moisture or heat.

  ●  Do not drop the remote control.

  ●  If the battery has leaked on the remote control, carefully wipe the case clean and install new batteries.

  ●  Risk of an explosion if battery is replaced by an incorrect type.

  ●  Dispose of used batteries according to the instructions or your local disposal rule or guidelines.

Open the battery

compartment lid.

Install new batteries

into the compartment.

Replace the

compartment lid.

For correct polarity

(+ and –), be sure

battery terminals are

in contact with pins in

compartment.

Point the remote control toward the projector (Infrared

Remote Receiver) when pressing the buttons. Maximum

operating range for the remote control is about 16.4'(5 m)

and 60 degrees in front of the projector.

The two different remote control codes (

Code 1 - Code 2) are assigned to this projector. Switching the remote

control codes prevents interference from other remote controls when several projectors or video equipment

next to each other are operated at the same time. Change the remote control code for the projector first before

changing that for the remote control. See "Remote control" in the Setting Menu on page 54.

Press and hold the MENU and IMAGE buttons for more

than five seconds to switch between the

Code 1 and Code 

2. The initial code is set to Code 1.

16.4’

(5 m)