Sanyo PLC-WL2503A User Manual

  No image

– Check the connection between your computer or video equipment

 

 and the projector. See pages 14-16. 

 

– See if the input signal is correctly output from your computer. Some

 

 laptop computers may need to change the setting for monitor output

 

when connecting to a projector. See your computer’s instruction

 

 manual for the setting.  

 

– It takes about 15 seconds to display an image after turning on the

 

 projector. See page 18.

 

– Check the Input signal, color system, video system or computer

system mode.

 

– Make sure the temperature is not out of the specified Operating

 

 Temperature (41˚F–95˚F [5˚C–35˚C]).

 

– When

No Show is operating, the image can not be displayed. Press

 

 the NO SHOW button or any other button on the remote control.

 No sound

– Check the audio cable connection from audio input source. 

 

– Adjust the audio source. 

 

– Press the VOLUME + button. See page 24. 

 

– Press the MUTE button. See page 24.

– When the AUDIO OUT is plugged-in, the projector's built-in speaker

is not available.

– Is the image projected? You will hear the sound only when the image

  is projected.

The color is strange . 

– Check the Input signal, color system, video system or computer

 

 system mode.

 

– Make sure the

Blackboard is not selected on Image select  

 

 Menu. See pages 33, 40.

  Some displays are not seen

– Check the Display function. See page 46. 

 

during  the operation . 

   

Auto PC adjustment function

– Check the Input signal. Auto PC function can not work when 

does not work .                                           480p, 575p, 720p, 480i, 575i, 1035i or 1080i is selected or when the

digital signal is input into HDMI terminal. See page 30.

 

The setting does not remain 

– Make sure you selected

Store after adjusting setting. Some settings

 

after turning off power .

 can not be stored if not registered with "Store". See pages 35,42.

 

Power management does not

– Power management function can not work while

Freeze or No   

 

Show is running. See page 51.

 

Capture function does not work .

– Check the connection and the input signal to see if there is signal.

 

Auto setup does not work properly .  – Make sure Off is not selected at any function of Auto setup. See page  

 

 45.