Sanyo 1080HD User Manual

Check the indicators for projector’s condition.  

• • • green

• • • red

• • • off

• • • blinking green

*

 

When the projection lamp reaches its end of life, the LAMP REPLACE indicator lights yellow. When this indicator becomes yellow, 
replace the projection lamp with a new one promptly. Reset the Lamp replacement counter after replacing the lamp. The time 
when the LAMP REPLACE indicator should light is depending on the lamp mode. See pages 49 – 50.

• • • blinking red

• • • blinking orange

• • • blinking yellow

POWER

WARNING 

LAMP 

REPLACE

The Main On/Off switch is off or the AC power cord is unplugged.

The projection lamp is being cooled down. The projector cannot be turned 
on until cooling is completed. 

The projector is ready to be turned on with the POWER ON/STAND-BY 
button.

The projector is operating normally.

The projector is in the Power management mode. 

The temperature inside the projector is abnormally high. The projector 
cannot be turned on. When the projector is cooled down enough and the 
temperature returns to normal, the POWER indicator emits red light and the 
projector can be turned on. (The WARNING indicator keeps blinking.)  Check 
and clean the air filter.

The projector has been cooled down enough and the inside temperature 
returns to normal. When turning on the projector, the WARNING indicator 
stops blinking. Check and clean the air filter.

The projector detects an abnormal condition and cannot be turned on.  
Unplug the AC power cord and plug it again to turn on the projector. If 
the projector is turned off again, unplug the AC power cord and contact 
the dealer or service center for servicing and checkup. Do not leave the 
projector on. It may cause an electric shock or a fire hazard.

The lamp does not turn on because malfunction occurs or the lamp reaches 
its end of life.

The automatic slide shutter is not working properly.

✽

✽

✽

✽

✽

✽

✽

✽