Sony PX35 User Manual

GB 

18

Connecting the Projector

• Turn off all equipment before making any connections.
• Use the proper cables for each connection.
• Insert the cable plugs firmly; loose connections may increase noise and 

reduce performance of picture signals. When pulling out a cable, be sure to 
pull it out from the plug, not the cable itself.

This section describes how to connect the projector to a computer.
For more information, refer to the computer’s instruction manual.

• The projector accepts 15k RGB, VGA, SVGA, XGA, SXGA, SXGA+ and UXGA 

(60 Hz) signals. However, we recommend that you set the output mode of your 
computer to XGA mode for the external monitor.

• If you set your computer, such as a notebook type, to output the signal to both your 

computer’s display and the external monitor, the picture of the projector may not 
appear properly. Set your computer to output the signal to only the external monitor.
For details, refer to the computer’s operating instructions supplied with your 
computer.

• This projector is compatible with a DDC2B (Digital Data Channel 2B). If your 

computer is compatible with a DDC, turn the projector on according to the following 
procedures.

Connect the projector to the computer by using the supplied HD D-sub 15-pin cable 
or DVI cable.

Turn the projector on.

Start the computer.