Sony VPL-VW60 User Manual

 

44

The Screen menu is used to adjust the input signal. You can adjust the size of the picture, 
and select wide screen mode, etc.

.

1 page 64, 65) is input.

Wide Zoom: A 4:3 aspect ratio picture is enlarged over the entire screen 

properly. The upper and lower portions of the screen are slightly cut 
off.

Normal: A picture with normal 4:3 aspect ratio is displayed in the center 

of the screen to fill the vertical screen size.

Full: A picture squeezed to 4:3 is displayed with the correct aspect ratio. 

A 4:3 picture is enlarged horizontally to fit the 16:9 screen.

Zoom: A normal 16:9 aspect ratio picture is enlarged vertically and 

horizontally in the same ratio to fill the screen.

Anamorphic Zoom: A 2.35:1 aspect ratio picture is converted to a 

normal 16:9 picture on the screen. This mode is best suited when 
using a commercially available Anamorphic lens which converts a 
normal 16:9 aspect ratio picture to a 2.35:1 picture.

You can set the aspect ratio of the picture to be displayed for the 
current input signal. This item is enabled only when a PC signal is 
input.
Full1: Displays a picture on the whole of the screen without changing 

the aspect ratio of the original picture.

Full2: Displays a picture on the whole of the screen.
Zoom: A normal 16:9 aspect ratio picture is enlarged vertically and 

horizontally in the same ratio to fill the screen.

Hides the outline of the picture.
On: Hides the outline of the input picture. Select this setting when noise 

appears along the edge of the picture.

Off: Projects the whole of the input picture.

Tip
To display the displayable region within the four directions of the screen, 
refer to “Blanking” on the Installation 

 menu (