Sony VPL-VW40 User Manual

 

44

The Screen menu is used to adjust the input signal. You can adjust the size of the picture, 
and select wide screen mode, etc.

.

1 page 63, 64) is input.

Wide Zoom: A 4:3 aspect ratio picture is enlarged over the entire screen 

properly. The upper and lower portions of the screen are slightly cut 
off.

Normal: A picture with normal 4:3 aspect ratio is displayed in the center 

of the screen to fill the vertical screen size.

Full: A picture squeezed to 4:3 is displayed with the correct aspect ratio. 

A 4:3 picture is enlarged horizontally to fit the 16:9 screen.

Zoom: A normal 16:9 aspect ratio picture is enlarged vertically and 

horizontally in the same ratio to fill the screen.

You can set the aspect ratio of the picture to be displayed for the 
current input signal. This item is enabled only when a PC signal is 
input.
Full1: Displays a picture on the whole of the screen without changing 

the aspect ratio of the original picture.

Full2: Displays a picture on the whole of the screen.
Zoom: A normal 16:9 aspect ratio picture is enlarged vertically and 

horizontally in the same ratio to fill the screen.

Hides the outline of the picture.
On: Hides the outline of the input picture. Select this setting when noise 

appears along the edge of the picture.

Off: Projects the whole of the input picture.

Tip
To display the displayable region within the four directions of the screen, 
refer to “Blanking” on the Installation 

 menu (

Selects the size of the picture when a Hi-Vision picture is 
overscanned.
Full: Expands the picture on the whole of the screen.
Through: Does not expands the picture on the whole of the screen.

This item is effective only when a Hi-Vision signal (preset memory No. 
7, 8, 9, 12, 13 and 14) is input and “On” is selected in “Over Scan”.