Sony KP-43T75A User Manual
– 42 –
KP-43T75A/53SV75A
RM-Y906
RM-Y906
5-6.
PIP POSITION ADJUSTMENT
(PI-PIPH, PIPV, PPH5, PPV5)
1. Set the PIP mode.
2. Receive the NTSC monoscope signal on the main/sub
2. Receive the NTSC monoscope signal on the main/sub
picture.
3. Check the sub picture position.
X1-X2
0.25sq
X1-X2
0.25sq
4. If necessary set to service mode and adjust "PIPH", "PIPV".
5. Write the data into memory.
5. Write the data into memory.
MUTING n ENTER
Fig. 5-7
Fig. 5-5
X1 = X2
X1
X2
5-5.
BAR DISPLAY POSITION ADJUSTMENT
(OP-DISP)
1. Receive the NTSC monoscope signal.
2. Set to service mode.
3. Push “ PICTURE +” . (Bar is displayed)
4. Select “ OP-DISP ” , and adjust so that the bar is as shown in
2. Set to service mode.
3. Push “ PICTURE +” . (Bar is displayed)
4. Select “ OP-DISP ” , and adjust so that the bar is as shown in
the figure.
5. Write the data into memory.
MUTING n ENTER
Fig. 5-6
Y2
X2
X1
Y1
5-7.
TEXT POSITION ADJUSTMENT
(CCD-CCHP)
1. Receive RF signal with text.
2. Check the text position.
2. Check the text position.
X1 = X2
4. If necessary set to service mode and adjust "CCHP".
5. Write the data into memory.
5. Write the data into memory.
MUTING n ENTER
6. Receive the PAL-N monoscope signal on the main/sub
picture.
7. Check the sub picture position as specified above.
8. If necessary set to service mode and adjust "PPH5", "PPV5".
9. Write the data into memory.
8. If necessary set to service mode and adjust "PPH5", "PPV5".
9. Write the data into memory.
MUTING n ENTER
X2
X1