Epson EB-520 User Manual

Name

Function

K

Air exhaust vent

Exhaust vent for air used to cool the projector internally.

Do not look into the vents. If the lamp explodes,
gases may escape and small fragments of glass may
be scattered which could cause an injury. Contact a
doctor if any fragments of broken glass are inhaled
or get into the eyes or mouth.

While projecting, do not put your face or hands
near the air exhaust vent, and do not place objects
that may become warped or damaged by heat near
the vent.

L

[A/V Mute] button

• Turns the video and audio on or off.

s

• Hold down the button for approximately three seconds

to perform auto pen calibration (EB-536Wi only).

M

Lens cover

Install when not using the projector to protect the lens
from being damaged or soiled.

Name

Function

A

Power inlet

Connects the power cord to the projector.

s

B

S-Video port

For S-video signals from video sources.

C

RS-232C port

When controlling the device from a computer, connect it
to the computer with an RS-232C cable. This port is for
control use and should not normally be used.

s

D

Video port

Inputs composite video signals from video sources.

E

Audio-L/R port

Inputs audio from equipment connected to the S-Video
port or the Video port.

F

Mic port

Inputs audio from the microphone.

s

G

Monitor Out port

Outputs analog RGB signals input from the Computer1
port to an external monitor. You cannot output signals
input from other ports or component video signals.

H

Audio1 port

Inputs audio from equipment connected to the
Computer1 port.