Epson EB-410W User Manual

The "aspectg" is the ratio between an image's length and its height. With this projector, you can switch the ratio by using the [Aspect] button on the remote 
control. The aspect ratio can be set in six modes; "Auto", "Normal", "16:9", "Full", "Zoom", and "Through". By switching the aspect, you can set the best 
projection for a given input signal. To set up, refer to the following explanation.

f

With the "Auto" setting, projection mode is switched according to the signal, as follows.
• 4:3 input signal: Normal
• Squeeze-recorded input signal: 16:9
• Letterboxing input signal: Zoom

*1 The "Auto" cannot be used for images from a computer and some component video signals.
*2 "Normal" is applied if the connected device does not conform to EIAJ standards.

f

The input signal, recommended aspect mode and the operation are as shown in the following table.

• Normal TV broadcast
• Standard-size (4:3) image 
• Computer image (including 

16:10 WXGA display 
images)

Normal

Makes full use of the 
projection area while 
maintaining the aspect 
ratio of the input image.

For 4:3 image

For 16:9 image

When projecting a 4:3 image, a black band 
appears to the left and right.
When projecting an HDTV image, the 
aspect ratio is 16:9 with a black band at the 
top and bottom.
When projecting a 16:10 image, the entire 
projection area is used.

1280

1067

800

1280

800

720