Epson EB-1420Wi User Manual

Check

Remedy

Is the Aspect Ratio

 set correctly?

You can change the Aspect Ratio of the projected image to suit the type, the ratio of height and width, and the resolution
of the input signals.

s

Has condensation formed on the lens?

If the projector is suddenly taken from a cold environment to a warm environment, or if sudden ambient temperature
changes occur, condensation may form on the surface of the lens, and this may cause the images to appear fuzzy. Set the
projector up in the room about one hour before it is used. If condensation forms on the lens, turn the projector off and
wait for the condensation to disappear.

Check

Remedy

Is the image signal format setting correct?
(Only when projecting images from a video source)

Change the setting according to the signal for the connected equipment.

s

 Signal - Video Signal 

Are the cables connected correctly?

Check that all the cables required for projection are securely connected.

s

Is an extension cable being used?

If an extension cable is used, electrical interference may affect the signals. Use the cables supplied with the projector to
check if the cables you are using may be causing the problem.

Is the correct resolution selected?
(Only when projecting computer images)

Set the computer so that the signals being output are compatible with the projector.

s

s

 Computer's documentation

Are the Sync.

 and Tracking

 settings adjusted correctly?

(Only when projecting computer images)

Press the [Auto] button on the remote control or the [

] button on the control panel to perform automatic adjustment.

If the images are not adjusted correctly even after performing automatic adjustment, you can also make adjustments
from the Configuration menu.

s

 Signal - Tracking, Sync. 

Is the Resolution set to anything other than Auto?
(Only when projecting on a split screen)

The image may be collapsed if the Resolution on the Configuration menu and the resolution of the projected image are
not the same.
If the image is collapsed, set the Resolution to Auto.

s

 Signal - Resolution 

Is Transfer layered window selected?
(Only when projecting USB Display)

Click All Programs - EPSON Projector - Epson USB Display - Epson USB Display Vx.xx Settings, and then clear the
Transfer layered window

 checkbox.