Epson EB-G5650W User Manual
By setting the Mail Notification function from the projector's
Configuration Menu, notification messages will be sent to the preset email
addresses when a problem or warning occurs with a projector. This will
enable the operator to be notified of problems with projectors even at
locations away from the projectors.
Configuration Menu, notification messages will be sent to the preset email
addresses when a problem or warning occurs with a projector. This will
enable the operator to be notified of problems with projectors even at
locations away from the projectors.
EB-G5900/G5800/G5600/G5500
s
Network Menu - Mail
EB-G5950/G5650W
s
Network Menu - Mail Menu
q
• Up to a maximum of three notification destinations (Addresses) can
be recorded, and notification messages can be sent to all three
destinations at once.
destinations at once.
• If a projector develops a critical problem and suddenly stops
working, it may not be able to send a message notifying an operator
of the problem.
of the problem.
• Monitoring is possible if Standby Mode is set to Communication
On
from the Extended menu of the projector's Configuration Menu,
even if the projector is in standby state (when the power is off).
s
s
Reading Problem Mail Notification Function
When the Mail Notification function is set to On and a problem/warning
occurs in the projector, the following e-mail is sent.
occurs in the projector, the following e-mail is sent.
Subject: EPSON Projector
Line 1: The name of the projector where the problem has occurred
Line 2: The IP address set for the projector where the problem has
occurred.
Line 3 and on: Details of the problem
Line 1: The name of the projector where the problem has occurred
Line 2: The IP address set for the projector where the problem has
occurred.
Line 3 and on: Details of the problem
The details of the problem are listed line by line. The following table shows
the details that are given in the message for each item. To deal with
problems/warnings, see "Reading the Indicators"
the details that are given in the message for each item. To deal with
problems/warnings, see "Reading the Indicators"
s
Message
Cause (Problems/Warnings)
Clean Air Filter
Air Filter Notice
Fan related error
Fan Error
High-speed cooling in progress
High Temp Warning
Internal error
Internal Error
Internal temperature error
High Temp Error
(Overheating)
(Overheating)
Lamp cover is open.
Lamp Cover Open
Lamp out
Lamp Error
Lamp replacement notification
Replace Lamp
Lamp timer failure
Lamp Failure
Low Air Flow
Low Air Flow
Low Air Flow Error
Filter Airflow Error
No-signal
No Signal
No Signal is input to the projector. Check
the connection status or check that the
power for the signal source is turned on.
No Signal is input to the projector. Check
the connection status or check that the
power for the signal source is turned on.
Power Err. (Ballast)
Power Err. (Ballast)
Sensor error
Sensor Error
A (+) or (-) appears at the start of the message.
(+): A projector problem has occurred
(-): A projector problem has been dealt with
(+): A projector problem has occurred
(-): A projector problem has been dealt with
Using the Mail Notification Function to Report Problems
114