Epson EB-G5650W User Manual

Sub Menu

Function

SNMP

Set this parameter to On when using SNMP

 to monitor the projector.

To use SNMP to monitor the projector, you need to install the SNMP manager program on your computer. SNMP should be managed by a network
administrator.

Trap IP Address 1/Trap IP
Address 2

When SNMP is set to On, you can set up to two IP addresses as SNMP trap notification destinations.
You can input a number from 0 to 255 in each field of the address.
However, the following IP addresses cannot be used.
127.x.x.x, 224.0.0.0 to 255.255.255.255 (where x is a number from 0 to 255)

Priority Gateway

For the priority gateway, select either Wired or Wireless.

AMX Device Discovery

When the projector is connected to a network, set this to On to allow the projector to be detected by AMX Device Discovery

. Set this to Off if you are

not connected to an environment controlled with a controller from AMX or AMX Device Discovery.

RoomView

Set this parameter to On only when using Crestron RoomView

®

 to monitor and control the projector over a network. Normally, leave this parameter set

to Off. s "About Crestron RoomView® (EB-G5950/G5650W only)" 

Changes in projector settings take effect upon restarting.
The following functions cannot be used when it is set to On.
• Web Control

• Message Broadcasting (EasyMP Monitor plugin)