Epson EB-Z8000WU User Manual

The  Remote  Control  does  not  work

Check

Remedy

Is the remote control light-emitting area pointing towards the
remote receiver on the projector when it is operated?

Point the remote control towards the Remote Receiver.
Operating range s Quick Start Guide

Is the remote control too far from the projector?

The operating range for the remote control is about 15 m. s Quick Start Guide

Is direct sunlight or strong light from fluorescent lamps shining
onto the Remote Receiver?

Set the projector up in a location where strong light does not shine onto the remote receiver. Or set the remote
receiver to Off from Remote Receiver in the configuration menu. s Settings Menu - Remote Receiver 

Is the correct setting for the remote receiver selected?

Check the Remote Receiver from the configuration menu. s Settings Menu - Remote Receiver 

Are the batteries dead or have the batteries been inserted correctly? Make sure the batteries are inserted correctly or replace the batteries with new ones if necessary. s 

Are the remote control ID and the projector ID matched?

Make sure the ID for the projector you want to operate and the ID for the remote control match. To operate all
projectors by remote control regardless of the ID setting, set the ID switch on the side of the remote control to Off.
s

Does Remote Control Type match the remote control that you
are using?

Check the Remote Control Type on the configuration menu. s Extended Menu - Operation - Remote Control
Type

 

Is the optional remote control cable connected to the remote
control or to the projector's remote port?

When the remote control cable is connected, the remote control light-emitting area or the projector's remote
receiver are disabled. When not using the remote control cable set, disconnect it from the remote control and the
remote port.

Nothing  appears  on  the  external  monitor

Check

Remedy

Are  images  input  from  a  port  other  than  the  Computer  or
BNC  input  port?

The  only  images  that  can  be  displayed  on  an  external  monitor  are  computer  images  from  the  Computer
or  BNC  input  ports.  s  

I  want  to  change  the  language  for  messages  and  menus

Check

Remedy

Change  the  Language  setting.

Adjust  the  Language  setting  from  the  configuration  menu.  s   Extended  Menu  -  Language