Epson EB-Z9870U User Manual

Page of 233
a
• Connect  the  USB  flash  drive  directly  to the  projector.  If  the
USB  flash  drive  is  connected  to  the  projector  through  a  USB
hub,  the  settings  may  not  be  saved  correctly.
• Connect  an  empty  USB  flash  drive.  If  the  USB  flash  drive
contains  data  other  than  the  batch  setup  file,  the  settings  may
not  be  saved  correctly.
• If you have saved a batch setup file from another projector to
the  USB  flash  drive,  delete  the  file  or  change  the  file  name.
The  batch  setup  function  cannot  overwrite  a  batch  setup  file.
• The file name for the batch setup file is PJCONFDATA.bin. If
you  need  to  change  the  file  name,  add  text  after
PJCONFDATA.  If  you  change  the  file  name  in  any  other  way,
the  projector  may  not  be  able  to  recognize  the  file  correctly.
• You   can   only   use   single-byte   characters   for   the   file   name.
c
While  holding  down  the  [Esc]  button  on  the  remote  control  or  the
control  panel,  connect  the  power  cord  to  the  projector.
When  the  projector's  indicators  turn  on  as  follows,  release  the  [Esc]
button.
Power
Status
Lamp1
Temp
Blue - On
Blue - On
Orange - On
Orange - On
When  all  of  the  indicators  start  flashing,  the  batch  setup  file  is  being
written.
 Caution
• Do not  disconnect  the power cord from the  projector  while the file is
being  written.  If  the  power  cord  is  disconnected,  the  projector  may  not
start  correctly.
• Do   not   disconnect   the   USB   flash   drive   from   the   projector   while   the
file  is  being  written.  If  the  USB  flash  drive  is  disconnected,  the
projector   may   not   start   correctly.
Batch Setup
50