Epson EH-TW2900 User Manual

Maintenance

Press the knobs to release the catches, 
and then pull the cover upward.

Press       or           to 
turn off the power, and 
then turn the main power 
switch OFF.

Remove the air filter 
cover.

Dispose of used air 
filters properly in 
accordance with 
your local 
regulations. 
Frame material: PP
Filter materials: PP, 
PET

TIP

* Wait until the lamp 

cools down (takes 
approximately 1 hour).

Insert the supplied screwdriver 
of  the replacement lamp into 
the lamp cover opening switch, 
then remove the lamp cover.

Securely tighten the 
lamp fixing screws.

Install the lamp cover.

Press       or           to 
turn off the power, and 
then turn the main power 
switch OFF.

If the lamp stops working 
and needs to be 
replaced, there is the 
danger that the lamp 
may already be broken.
If replacing the lamp of a 
projector which has been 
installed to the ceiling, 
you should always 
assume that the lamp is 
broken and handle it with 
extreme care during 
removal. Furthermore, 
you should stand to the 
side of the projector, not 
underneath it.

Press       to turn on 
the power.

Press              to display 
the configuration menu.

The lamp operating time 
must always be reset after 
the lamp has been replaced 
with a new one.
The projector has a built-in 
counter which keeps track 
of the lamp operating time. 
When the cumulative 
operating time reaches a 
certain point, it causes the 
replacement warning 
message to be displayed.