EIKI LC-XB200 User Manual

To ensure safe operation, please observe the following precautions :

 ● Use two (2) AAA or LR03 type alkaline batteries.

 ● Always replace batteries in sets.

 ● Do not use a new battery with a used battery.

 ● Avoid contact with water or liquid.

 ● Do not expose the remote control to moisture or heat.

 ● Do not drop the remote control.

 ● If the battery has leaked on the remote control, carefully wipe the case clean and install new batteries.

 ● Risk of an explosion if battery is replaced by an incorrect type.

 ● Dispose of used batteries according to the instructions or your local disposal rule or guidelines.

Open the battery

compartment lid.

Install new batteries

into the compartment.

Replace the

compartment lid.

Point  the  remote  control  toward  the  projector  (Infrared

Remote  Receiver)  when  pressing  the  buttons.  Maximum

operating  range  for  the  remote  control  is  about  16.4'(5  m)

and 60 degrees in front of the projector.

16.4'
(5 m)

30° Remote control

30°

Press the lid

downward and slide it.

For correct polarity

(+ and –), be sure

battery terminals are

in contact with pins in

compartment.

While  pressing  the  MENU

button,  press  the  IMAGE

button  number  of  times

corresponding to the remote

control code.

The eight different remote control codes (Code 1–Code 8) are assigned to this projector. Switching the remote

control  codes  prevents  interference  from  other  remote  controls  when  several  projectors  or  video  equipment

next to each other are operated at the same time. Change the remote control code for the projector first before

changing that for the remote control. See "Remote control" in the Setting Menu on page 55.

While pressing the MENU button, press the IMAGE

button number of times corresponding to the remote

control code. See the list below.

To initialize the remote control code, slide the RESET/

ON/ALL-OFF  switch  to

RESET,  and  then  to ON. The

initial code is set to Code 1.