EIKI LC-XB200 User Manual

 Problem:

– Solutions

 No power

– Plug the power cord of the projector into the AC outlet.

 

– See if the POWER indicator lights red.

 

– Wait until the POWER indicator stops blinking to turn on the projector

again. The projector can be turned on after the POWER indicator

turns red. See page 20.

 

– Check the WARNING indicator. If the WARNING indicator lights red,

projector cannot be turned on. See page 61.

 

– Check the projection lamp. See page 64.

 

– Unlock the Key lock function for the projector. See page 56.

The initial display is not shown . – Make sure Off or Countdown off are not chosen at display  

function. See page 48.

The initial display is not same – Make sure User or Off are not chosen at Logo (select)

as the default set . function. See page 49.

Input signal switches automatically . – Make sure Input search function is adjusted properly. See page 47.

when the projector is on and you – That is the Filter warning icon. See page 58.

appears.

An icon other than Input mode or – That is the Lamp replacement icon or the Filter warning icon. See

Lamp mode icon appears . pages 58 or 64.

Image is out of focus .

– Adjust focus of the projector. See page 25.

 

– Provide proper distance between the projector and the projection

 

 screen. See page 15.

 

– Check the projection lens to see if it needs cleaning. See page 63.

 

– Moving the projector from a cool to warm place may result in  

 

 moisture condensation on the projection lens. In such cases, leave

 

 the projector off and wait until condensation evaporates.

Image is Left/Right reversed .

– Check the Ceiling/Rear function. See page 52.

Image is Top/Bottom reversed .

– Check the Ceiling function. See page 52.

– Check if the

Contrast or Brightness is adjusted properly. See

 

 pages 36,43.

 

– Check if

Image mode is selected properly. See pages 35,42.

 

– Check the lamp control function. See pages 27,54.

 

– Check the LAMP REPLACE indicator. If it lights, the end of lamp life

 

 is approaching. Replace the lamp with a new one promptly. See page

 

 64.

Before calling your dealer or service center for assistance, check the items below once again.

– Make sure you have properly connected the projector to peripheral equipment as described on pages 16-18.

– Make sure all equipment is connected to AC outlet and the power is turned on.

– When the projector does not project an image from the connected computer, restart the computer.