JVC DLA-SH4K User Manual
22
Operation and Settings
If setting for this projector is not completed, refer to the
“Setting Menu” (
“Setting Menu” (
A Page 24) upon turning on the power
and configure the settings accordingly.
Once the basic settings are configured, this projector can
be used by simply performing the following operation
procedures.
Once the basic settings are configured, this projector can
be used by simply performing the following operation
procedures.
PREPARATION:
● Remove the lens cap.
● Connect this projector to the computer. (A Page 17, 19)
● Connect the LAN cable. (A Page 20)
1
Set this projector to the standby mode, and
display the main menu
● Refer to “Configuring the Network Settings”.
● The [STANDBY/ON] indicator lights up in red.
2
Click the
of the main menu to project the image
● The power of this projector turns on, and the
projected image appears.
● The [STANDBY/ON] indicator lights up in green.
NOTE:
● You can also turn on the power by pressing the
B] button on the projector unit for more
than one second.
● The image may flicker for a few seconds immediately
after projection starts. This is not a malfunction.
● After the lamp lights up, it takes about 1 minute or
longer for the brightness of the video image on the
screen to stabilize.
screen to stabilize.
3
Adjust the zoom ratio (screen size)
You can adjust the focus using the
AZoomB item of the
Lens menu.
To enlarge the screen size:
Press the
To reduce the screen size:
Press the
ATB (Tele) end of “Zoom”
NOTE:
● The screen size changes each time you click on the
inner buttons ( / ). (Fine control)
The outer buttons ( / ) change the screen size when
they are depressed. (Coarse control)
The outer buttons ( / ) change the screen size when
they are depressed. (Coarse control)
4
Adjust the position of the projection screen
You can adjust the focus using the
AShiftB item of the
Lens menu.
To shift the image upward:
Press the
To shift the image downward:
Press the
To shift the image rightward:
Press the
To shift the image leftward:
Press the
NOTE:
● The adjustment range for lens shift is between 0 %
and ±50 % in the vertical direction, and between 0 %
and ±25 % in the horizontal direction (during single-
screen display).
and ±25 % in the horizontal direction (during single-
screen display).
● The position changes each time you click on the inner
buttons ( / ). (Fine control)
The image shifts when the outer buttons ( / ) are
depressed. (Coarse control)
The image shifts when the outer buttons ( / ) are
depressed. (Coarse control)
Projecting Image
Main
DVI
Rate(Hz)
Pixel H
Pixel V
Link
1
60.00
2048
2400
Dual
2
3
60.00
2048
2400
Dual
4
Image
Setting
Convergence
Lens
Option
Network
Mail
Logout
host PJ-1
user: root
user: root
Power
Signal Status
Projector Usage
Latest Error
Temperature
Lamp Time
1035h24m
Temp. 1
36.0 deg.C
Temp. 2
25.5 deg.C
ON
OFF
STANDBY
00
Reset
Zoom
Setting
Convergence
Lens
Option
Network
Mail
Logout
host PJ-1
user: root
user: root
Main
Image
w
T
Focus
+
_
Shift
L
R
U
D
DLA-SH4_EN.book Page 22 Tuesday, January 15, 2008 6:07 PM